Manufactered by : CRC Industries Europe NV Touwslagerstraat 1 – 9240 Zele – Belgium Tel  (32) (0) 52/45.60.11  Fax  (32) (0) 52/45.00.34 Technical Data Sheet KONTAKT CHEMIE Tuner 600 Page 1/2 Precision cleaner for contacts KONTAKT CHEMIE Tuner 600 Description: Quick-drying solvent cleaner, leaves no residue and is neutral on materials. Does not contain aromatic and chlorinated hydrocarbons. General properties and applications: KONTAKT CHEMIE Tuner 600 was specially developed for sensitive tuner contacts and is an  outstanding  contact  cleaner  for  electrically  and  mechanically  critical  areas.  Its  gentle cleaning  power  makes  it  particularly  well-suited  to  sensitive  components  or  materials.  It  is safe for use on rubber or synthetics.   This   product   is   used   in   consumer   electronics   as   well   as   in   computer   or   TV   and telecommunications  technology.  It  cleans  dust  and  oily  and  greasy  residues  from  e.g. potentiometers  and  linear  regulators,  sensors  or  graphite  conductor  layers  of  IR  remote controls. It  dries  in  seconds,  leaving  no  residue.  Thanks  to  the  low  surface  tension  of  the  cleaning solution it can also clean in concealed places or in fine cracks. Technical data Odour Mildly of solvent Flash point ASTM D 56 < 0°C Evaporation rate (ether=1) DIN 53 170 1 (in a second) Boiling range ASTM D 1078 40 °C to 65 °C Density ASTM D 891 0.67 g / cm³ Surface tension ASTM D 971 17 mN/m

Manufactered by : CRC Industries Europe NV Touwslagerstraat 1 – 9240 Zele – Belgium Tel  (32) (0) 52/45.60.11  Fax  (32) (0) 52/45.00.34 KONTAKT CHEMIE Tuner 600 Page 2/2 Application instructions: KONTAKT  CHEMIE  Tuner  600  cleans  all  contact  materials  safely  and  leaves  no  residue. The  aerosol  also  sprays  upside  down  and  comes  with  an  extension  tube,  allowing  easy cleaning of small parts. Brushing or wiping improves the cleaning effect.   KONTAKT CHEMIE Tuner 600 has a low flash point and therefore dries very quickly and. Because  the  product  is  flammable,  care  must  be  taken  when  working  with  the  product. Ensure there are no ignition sources (naked flames, sparks, incandescent surfaces) nearby. The  product  must  also  not be used in live electrical sub-assemblies. The cleaner must be completely evaporated before electrical equipment is switched on. Ensure the workplace is well-ventilated when using this product. Additional safety information can be found in the safety data sheet. Available:   Aerosol: 200 ml These values are not intended to be used as specifications. They are based on what we believe reliable.   However it is the user’s responsibility to determine the suitability.